AbiSee Eye-Pal READER Manual de usuario descargar pdf (Pagina 11)

2. Auto Mode:

a) Click the Start Auto Mode Button.

b) Place the open book under the camera and use both hands to flatten the

page. In a few seconds you will hear the shutter sound, as the page has been

scanned and saved.

c) Turn the page, again keep the page flat and in a few seconds you will hear

the same sound.

d) Continue turning pages until you have all the pages you want to be scanned

and saved.

e) When you are done or need a break, click the Stop Auto Mode button and

remove the book from under the camera.

f) When you are completely finished saving pages, click the Done button. The

Add Pages Book bar will disappear, and the Read Mode Book bar will

appear.

Note: You can add more pages to this book later. See Adding Additional

Pages to an Existing Book section of the manual for more details.

The Read Mode bar allows you to easily read your saved book with navigation

buttons. For more information on reading your book with the Read Mode Book bar,

see Reading a Saved Book topic below.

If you are done with your book, click the Exit button to close the book.

More tips on saving a Book

1.Place a piece of white paper under the camera and place a book on the paper. Then

Eye-Pal will not scan the background as part of your document.

2.Make the book as flat as possible. If you are saving a thick book with many pages,

choose the Auto mode and use both hands to flatten the book.

3.When you are saving a book in Auto mode, Eye-Pal will automatically adjust

brightness to the light conditions at that time. If you are taking a lot of time

saving all of the pages, take a break occasionally. Click Stop Auto Mode and then

click Start Auto Mode to allow Eye-Pal to re-adjust the brightness according to

the illumination of your room.

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 19 20

Sin comentarios

AbiSee Eye-Pal READER Manual de usuario Pagina 11